ZTE 801a Ethernet keeps dropping
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Highlight
- Report Inappropriate Content
on โ01-20-2023 07:37 PM
I have the ZTE801a and the Ethernet ports just stop working, I switch it around they work again then stop I switch them back and they work again and it repeats it again and again anyone else had this problem or does the router need flying lessons !
Solved! Go to Solution.
- Labels:
-
5G
-
Home Broadband
-
Wi-Fi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Highlight
- Report Inappropriate Content
on โ01-29-2023 01:45 PM
Three admitted router at fault so sent me a replacement
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Highlight
- Report Inappropriate Content
on โ01-29-2023 01:45 PM
Three admitted router at fault so sent me a replacement
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Highlight
- Report Inappropriate Content
on โ01-20-2023 10:58 PM
I have same router but do not as router only using modem so all wifi disabled just one port using for wan
Look like working ok Just three limiting speed this is bad "traffic management "
The router when I tested via wifi feels little week I mean for my need this wifi to week will be overloaded from my equipment
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Highlight
- Report Inappropriate Content
on โ01-20-2023 11:04 PM
- My router firmware / software last digits B12
- Try to reset router you can do this advance settings > other > reset
- I have try couple things on router and it did not like changes and my wan port was put on router side and no matter what I done the settings gone inside parameters and to fix this was reset then I know now do not touch as router is locked and there is minimal what can be done

